Pinhole Detector for Alu-Alu blisters

pic

LIXIS MH systems are designed to automatically detect pinholes and pores on Alu-Alu blister packs produced during foil cold forming, which are usually invisible to human eye.

Our equipment eliminates non-airtight sealing risks due to cracks in the inspected foil, impossible to detect with other automatic systems. Therefore, an accurate control of 100% of the production is guaranteed, a rate that cannot be equalled by statistical sampling.

Technology

  • System based on highly sensitive detection of infrared radiation.
  • Detects 25 micron (0.001 inch) pinholes.
  • Inspects multiple independent areas on foil.

Simplicity

  • Fully automatic and easy to adjust. › Easy and reliable system calibration by means of laser drilled standard apertures.
  • Compact design – Easy to clean and install on any blister machine.

Efficiency

  • Does not slow down blister machine production speed.
  • Virtually maintenance-free. Only requires programmed cleaning.
  • Unbeatable cost-efficiency ratio.

Quality Assurance

  • Controls 100% of the Alu-Alu blister production and eliminates risk of non-airtight sealing due to cracks in inspected foil.
  • Fail Safe – Any malfunction in the system will cause machine-stop and blister rejection.
  • Designed under cGMP. Compatible with any production environment.
picture